Giga-tronics 58542 - Page 91

Operation
Publication 21555, Rev. E, September 2002 2-61
FETCh1? Data corrupt or stale
TTL trigger mode not applicable
No valid sensor
Normal mode
INITiate:IMMediate Init ignored Continuous is on
MEASure1? Data corrupt or stale
Normal mode is off
No valid sensor
Burst or swift mode
MEMory:TABLe:FREQuency No valid sensor
V
PROP
F Table is not selected
V
PROP
F Table freq data error
No sensor
Select others
Start freq is greater than sensor
maximum
MEMory:TABLe:POWer Analog out Table is not selected
Analog out Table data input error
Other table
Lower power is greater than
upper power
MEMory:TABLe:SLOPe No valid sensor
V
PROP
F Table is not selected
Select others
No sensor
MEMory:TABLe:UNIT Analog out Table is not selected Other table
MEMory:TABLe:VOLTage Analog out Table is not selected
Analog out Table data input error
Other table
Lower voltage is greater than
upper voltage
READ1? Data corrupt or stale
Normal mode is off
Trigger deadlock
No valid sensor
Burst or swift mode is on
TRIG:SOUR is not in IMM
mode
SENSe1:EEPROM:CALFactor?
SENSe1:EEPROM:FREQuency?
No valid sensor
Sensor eeprom data is over space
No sensor
Too much data
SENSe1:CORRection:VPROpf:STATe No valid sensor No sensor
SENSe1:TRIGger:DELay
SENSe1:TRIGger:LEVel
No valid sensor
Sensor is in CW source mode
No pulse sensor
SENSe1:TRIGger:DELay:STATe ON No valid sensor No pulse sensor
TRIGger:COUNter Normal mode is on
Counter has to be one in Swift immediate source
No valid sensor
Channel is not valid
Not in burst or swift mode
Swift mode, imm source
No sensor
Ratio mode setup
TRIGger:IMMediate Init ignored Source is in immediate mode
TRIGger:MODE PRE No PRE mode for trigger immediate source
TRIGger:SOURce:IMMediate Counter has to be one in Swift immediate source
No valid sensor
Channel is not valid
Swift mode is on
No sensor
Ratio mode setup
Table 2-7: Device Specific Error Messages (Continued)
Command Error Message Example of Problem