Giga-tronics 58542 - Table 2-7: Device Specific Error Messages

58542 VXIbus Universal Power Meter
2-60 Publication 21555, Rev. E, September 2002
Table 2-7: Device Specific Error Messages
Command Error Message Example of Problem
ABORt
CALCulate1:DATA? Burst mode is off Not burst mode; Command
requires BURSt mode
CALCulate1:DIFFerence 1,1
CALCulate1:RATio 1,1
Conflict in channel configuration Same sensor
CALCulate1:LIMit:LOWer:UPPer Conflict between upper and lower limits Upper is smaller than lower
or lower is greater than
upper
CALCulate1:MAXimum:STATe Channel is not valid No sensor or sensor not
calibrated
CALCulate1:MINimum:STATe Channel is not valid No sensor or sensor not
calibrated
CALCulate1:MODE No valid sensor
Channel is not valid
No sensor
No sensor or sensor not
calibrated
CALCulate1:REFerence:COLLect Normal mode is off
Channel is not valid
Burst mode setup
No sensor or sensor not
calibrated
CALibrate1 No sensor
Sensor not connected to calibrator
Sensor calibration error
No sensor
Calibration error
CALibrate1:ZERO No sensor
Sensor zeroing error Zeroing error
DIAGnostic:SENSe1:EEPROM:CORRection No valid sensor
sensor eeprom data:correction factor number does not
match
No sensor
DIAGnostic:SENSe1:EEPROM:READ No valid sensor No sensor
DIAGnostic:SENSe1:EEPROM:CALFSPecial
DIAGnostic:SENSe1:EEPROM:CALFSTandard
No valid sensor
Sensor eeprom data is over space
Sensor eeprom data:cal factor number does not
match
No sensor
Too much data
DIAGnostic:SENSe:EEPROM:FREQSTandard? No valid sensor
Sensor eeprom data is over space
No sensor
Too much data
DIAGnostic:SENSe1:EEPROM:CALFRange
DIAGnostic:SENSe1:EEPROM:TYPE No valid sensor No sensor
DIAGnostic:SENSe1:EEPROM:FREQSPecial No valid sensor
Sensor eeprom data is over space
Sensor eeprom data:freq is above upper freq limit
Sensor eeprom data:freq is below lower freq limit
Sensor eeprom data:freq number do not match
No sensor
Too much data
DIAGnostic:SENSe1:EEPROM:TYPE No valid sensor
Sensor eeprom data:upper freq should be larger than
lower freq
No sensor
DIAGnosticSENSe1:EEPROM:WRITe No valid sensor
Sensor eeprom data:write error
Password is incorrect
No sensor
Sensor eeprom error
Password is activated