10
Installation
GBF-50 Fryer
2.08 Restraint Device (not included, provided by customer)
This appliance requires use of an appropriate Restraint Device to prevent unintentional movement, which could cause
undue strain on electrical connections. The length of a restraining cable must be shorter than the electrical supply cord
or conduit. A restraint anchor shall be fastened to an immovable wall or structure. Install a quick‐release latch on one
end of the cable for connecting to the factory‐installed eye‐bolt(s) on the rear of the unit. Restraint is required at each
end of a banked system.
* Anchor attached to an immovable
wall or structure.
* Restraint Cable
* Quick‐release
Latch
Eye Bolt
* Customer provided
Every effort is made to ensure that new GILES fryers are in perfect operating condition when received; each one has
passed rigorous quality control testing prior to shipment. To ensure that it has been properly installed and will operate
as expected when placed into service, we recommend that, after installation is complete, the following steps be
performed to check basic functionality of fryer systems and to prepare the appliance for first use.
Before proceeding, please refer to Section 3 to become familiar with various controls, fryer systems and
functions. After reading and fully understanding this information, perform the following steps precisely to avoid
possibly damaging the equipment.
2.09 Finalizing Installation
Continued on Next Page
To Next Page
Loading...
