GILES GBF-50 - Loading Product for Cooking

49
Fryer Operation
GBF-50 Fryer
7. When cooking oil reaches the programmed temp setpoint, the alarm sounds and display reads “ALARM ‐ STIR
OIL”. Press [ALARM] key ⑤ to silence and vigorously stir oil with the provided stirring tool. The controller
enters a programmed ten (10) second delay ... if oil temperature drops below setpoint while stirring, PREHEAT
mode continues until the setpoint is reached again. The alarm sounds again and display reads “ALARM ‐
SETPOINT REACHED”. Press the [ALARM] key ... controller enters READY state. The lower display changes from
actual temperature readout to show the cooking temperature setpoint.
Cooking oil should now be evenly heated and ready for cooking.
Continued on Next Page
4.02.1 Filling & Preparing Fryer for Cooking - continued
8. After fully heating, confirm the oil level ... it should now be at or near the [FULL]
mark. If not, add the needed amount of oil and stir again. If the HEAT light turns
ON after adding additional oil, stir until it turns OFF again before cooking.
4.02.2 Loading Product for Cooking
1. Place crumb/support screen(s) ① into vat(s) ... handles to the side. Screen will rest
on brackets affixed to the vat sides.
2. The standard GBF‐50 fryer is equipped with a basket hanging rack along the back
cabinet header ... hang empty baskets ② there.
Optional Auto‐basket Lifts: If the basket lift option is installed on your fryer, place
the cooking baskets onto the basket carrier ③ holder arms.
When the basket lift option is installed and you wish to utilize the
feature when cooking, set the control panel Lift Switch ④ in the [LIFT]
position. There will be no switch if the option is not installed.
See Section 4.01.7.1 for details about manually operating optional
basket lifts.
2
1
4
NOTE:
If you do not wish to use the installed lifts, move them to the [UP] position (see Section 4.01.7.1) and set the Lift
Switch to [OFF]. The lift carriers can now be used as a manual basket hanger.
While cooking, oil level MUST be maintained between [FULL] & [ADD] levels. If oil level falls
below [ADD], the controller may issue a LOW OIL LEVEL error & alarm, and as safeguard
against fire, the heating elements will be turned OFF and remain disabled until the condition corrected.
3