1. Carefully cut and remove the plastic stretch film, strapping and any other packing material.
2. Filter Pan and fryer accessories (baskets, screens, fryer tools, etc) are either packed inside the fryer cabinet and
the vat. Remove these items and set aside in a safe place.
3. Carefully remove fryer from shipping pallet. Fryers can be very heavy, especially banked systems. Great care
should be taken when lifting or moving the unit to avoid personal injury or damage to the unit. Use of
appropriate material handling equipment is recommended when removing banked units from shipping pallet.
2.02 Unpacking - continued
IMPORTANT!
Damages to the unit caused by improper use of material handling equipment or poor work practices are not
covered by Giles’ warranty. Giles shall not be liable for personal injuries or property damage which may be
incurred during installation of this equipment. Installation is the sole responsibility of the purchaser, unless
previous arrangements have been made in writing.
Installation
6
GBF-50 Fryer
2.03 Electrical Requirements
IMPORTANT!
If crated unit showed evidence of damage or mishandling, immediately inspect the unit and all accessory items
and notify the freight carrier of any damages. Generally, it is the purchaser’s responsibility to file and negotiate
claims for freight damage.
• Fryers must be properly grounded in accordance with local code, or in the absence of local code, with the
National Electrical Code, ANSI/NFPA 70. Improper grounding may result in electrical shock to users. Check local
electrical code to ensure that proper grounding techniques are utilized.
• Always consult a licensed electrician, or other qualified technician, prior to installation to ensure that the
electrical circuit to which the unit is to be connected is of sufficient rating to handle the appliance load.
• GBF Fryers are manufactured with various electrical specifications as shown in Table 2.04. Check the Serial/Data
Label inside the cabinet or attached to the rear panel to determine the proper electrical service required for the
unit being installed. Each unit of a banked battery requires a separate power supply.
To Next Page
Loading...
