29
because the rst phase has no end. The hold phase is an exception,
which can be set on "INFINITY" and then have one or more successive
phases, which must however be started manually� E�g� in the night time
cooking of roast dishes, it is preferred to brown the dish on return of the
operator to the kitchen, therefore after the hold phase�
To pass from one cooking phase to another, hold the number of the
phase to which you want to pass down, or use the arrows to select the
desired phase number and press the "GO" button at the side of the
phase number�
The program of a specic phase can be started (different from the
rst set): after having selected the program, press the “Advanced
Customisation” key and use the arrow to go to the desired phase� On
pressing Start, the program will start from this phase�
If pre-heating was envisioned in this program, it will not be performed�
TheprogramcanbemodiedusingtheCookingTunerinterfacebefore
pressing the "Advanced Customisation" button�
2.6 Creating a cooking program
A cooking program is made up from several phases, which the oven
performs in increasing order (phase 1, phase 2, phase 3���) passing from
one to another automatically�
After having set the parameters
relative to the initial phase (phase 1),
press the new phase button (ref. 12)
to create the next phase�
Therefore, set the parameters of phase 2�
Continue with passages 1 and 2 to
create additional phases� It is also
possible to create and insert new
phases between the old phases� The new phase will be positioned under
the one you have selected during the typing of the button “new phase”�
At the end of programming, press START to start cooking�
Press the “Eliminate Phase” button to delete a phase (ref. 13)�
START
12
13
New Phase
Delete Phase
To Next Page
Loading...
