48
Washing interruption
You can stop the wash cycle by holding down the knob and entering the
password 222.
If the detergent has already been loaded, the rinse phase followed by
the drying phase start up; if, instead, it has not yet been loaded, the
cycle shuts down immediately�
3.2 COOLING
This function allows to quickly reduce
the temperature inside the oven chamber,
to pass from a high temperature type of
cooking, to more delicate cooking, which
requires lower temperatures (e�g� to pass
from roasting to steaming vegetables)�
By starting this function by pressing the
START key, the fan will begin functioning�
Open the oven door to promote the exit
of hot air and the entry of cooler air� This
allows the desired temperature to be
reached in a short time and to proceed
with more delicate cooking�
For safety reasons, the cooling function
can be enabled only with the door closed�
The door can be opened only after this
program has started�
By default the oven proposes cooling of the
chamber to 50°C, but the desired value can
be set� Upon reaching this temperature, the
oven stops cooling and emits an acoustic
signal�Once the cooling is started you can
manually spped up the process by entering
water in the cooking chamber� You can activate this function
holdingthebutton“manualhumidier”g.18 for the desired time�
ATTENTION: HOT AIR AND STEAMS JETS COULD
OVERFLOW FROM THE COOKING CHAMBER! BURNS HAZARD!!
3.3 SERVICE
There are 4 functions in this menu: CONFIGURATION; BOILER CLEANING,
LOG DISPLAYS; ADVANCED SERVICES which give the possibility to
adjust and display a range of functions and start the procedures for
maintenance of the oven�
50°
START
Fig. 18
To Next Page
Loading...
