8. Defining and Running Sequences
A sequence is a combination of a number of methods. Each method can be run automatically a
predefined number of times within a sequence. Sequences can be defined and run using the
Evolution Workstation software.
8.1 Defining Sequences using Evolution Workstation Software
Select File/New/Sequence. Click Insert to insert any previously defined method. You can also specify
the number of times it should be executed. This is done by clicking the method and then using the
Repeat up/down arrows on the right of the screen. Once the number of repeats has been selected,
press Apply to confirm. To move a method up or down in the sequence, click to select it and then
click Up or Down to move it up or down in the list. Similarly, you can remove a method from the
sequence. The sequence can also be looped by checking the relevant box. Once it has been created
the sequence is saved by selecting File, Save.
8.2 Running Sequences using Evolution Workstation Software
Once a sequence has been created with the software, it can be activated, executed, stopped, etc. by
selecting Sequence and the relevant option.
Select Execute to upload and start the first method in the sequence.
To Next Page
Loading...