GL Sciences OPTIC-4 - Appendix A: OPTIC-4 Default Configuration Parameters; Standby Parameters; System Configuration Parameters

OPTIC-4 User’s Guide
Issue 5.3
Default Configuration Parameters
Page A-1
Appendix A: OPTIC-4 Default Configuration Parameters
A.1. Standby Parameters
Parameter Name
Default Value
Allowed Range
Inlet Temperature
35 C
-180 - 600 C
Inlet Temperature Control
Yes
Yes/No
Inlet Cooling
OFF
ON/OFF
Column Flow
1.0 mL/min
0.0 - 20.0 mL/min
Split Flow
50.0 mL/min
1.0 - 450 mL/min
Split Valve State
Split
Split/Splitless
Septum Purge Flow
5.0
1.0 - 10.0 mL/min
Inlet Zero Pressure
No
Yes/No
Auxiliary Flow (OPTIC-4D and OPTIC-4DC)
10.0
2.0 - 100 mL/min
Auxiliary Pressure (OPTIC-4D and OPTIC-4DC)
100 kPa
5.0 - 500 kPa
Cryotrap Temperature
35 C
-150 - 350 C
Cryotrap Temperature Control
No
Yes/No
Cryotrap Cooling
OFF
ON/OFF
Timeout
30:00 min:sec
0 - 500 min
Run/Ready Signal Through Function
No
Yes/No
Auxiliary Output 1
Open
Open/Closed
Auxiliary Output 2
Open
Open/Closed
Auxiliary Output 3
Open
Open/Closed
Auxiliary Output 4
Open
Open/Closed
A.2 General System Configuration Parameters
Parameter Name
Default Value
Allowed Range
Maximum Temperature
350 C
100 - 600 C
Communication Interface
USB
USB/LAN
Main EFC
Yes
Yes/No
Auxiliary EFC
No
Yes/No
Cryotrap
No
Yes/No
Pressure Unit
kPa
kPa/psi/bar
Auxiliary Channel Flow/Pressure Control
Flow
Flow/Pressure
Keyboard Beeper
Enabled
Enabled/Disabled
Reset Parameters
No
Yes/No