1. Precautions and Warnings
This section explains the warnings and cautions that should be observed when installing or operating
OPTIC-4.
Safety information is covered at relevant points throughout the manual. Please read this manual in
its entirety before installing or operating the instrument. Should any point remain unclear, contact
your supplier for assistance before proceeding.
NOTE:
Warnings, precautions and other items of interest are indicated by the following
conventions:
WARNING! Indicates a potentially hazardous situation, which, if not avoided,
could result in moderate to serious injury or possibly death.
CAUTION! Indicates a potentially hazardous situation, which, if not avoided,
could result in minor injury or equipment damage.
NOTE Emphasizes additional information that is provided to ensure proper
use of this instrument.
1.1 General Precautions and Warnings
1. Use OPTIC-4 for specified types of analyses only.
2. Follow the procedures as written in this manual.
3. Do not modify or disassemble instrument without an express approval of GL Sciences B.V. or
its authorized representative as this may compromise safety.
1.2 Installation Precautions and Warnings
OPTIC-4 is designed for installation and use in a laboratory environment by suitably trained
personnel. All relevant safety aspects should be assessed in accordance with the local
regulations before installing and commissioning the instrument.
1. An GL Sciences representative must perform instrument installation and configuration. To
prevent potential injuries, contact an GL Sciences representative if the instrument must be
moved after installation.
2. OPTIC-4 is intended for use in appropriately equipped analytical laboratories. Solvents used
for analysis are flammable and toxic. Install the instrument in a very well ventilated room.
To Next Page
Loading...