GME TX6600PRO - Page 52

TX6600PRO INSTRUCTION MANUAL
48
6. Press
MENU
F
to advance to the next position.
7. Repeat steps 5 & 6 to enter all 5 Ident digits or up to 6 Alpha
characters, then hold
MENU
F
to save. The eld will ash 3 times to
conrm it has been saved.
8. Briey press
MENU
F
to toggle between Ident and Alpha modes.
9. Hold
MENU
F
to edit the new eld.
10. Repeat steps 5, 6 & 7 to enter the desired characters or numbers into
the eld.
11. Hold
MENU
F
to save. The eld will ash 3 times to conrm it has been
saved.
12. Press
CALL
LOCK
to return to the CALL sub-menu.
13. Press
CALL
LOCK
again to return to normal operation.
10. Repeat steps 5, 6 & 7 to enter the desired characters or numbers into the field.
11. Hold to save. The field will flash 3 times to confirm it has been saved.
12. Press to return to the CALL sub-menu.
13. Press again to return to normal operation.
‘Saved’ Menu Empty Memory Location Editing the SelCall Ident
Selecting the Alpha Name Field Entering an Alpha Name
Editing an existing Contact
1. Press to enter the SelCall Menu.
2. Rotate the Channel knob or press the keys to cycle to the SAVED option then press
to select.
3. Rotate the Channel knob or press the keys to cycle to the desired contact.
4. Briefly press to toggle between Alpha and Ident modes. When the desired field is
displayed, hold to select it. One of the characters will flash.
5. Rotate the Channel knob or press the keys to edit the desired character in the
flashing position.
6. Press to advance to the next character position.
7. Repeat steps 5 & 6 as necessary to edit the field, then hold to save. The field will flash
3 times to confirm it has been saved.
8. If required, briefly press to toggle between Ident and Alpha modes, then repeat steps
5 & 6 to edit the field.
9. When complete, hold to save. The field will flash 3 times to confirm it has been saved.
10. Press to return to the CALL sub-menu.
11. Press again to return to normal operation.
Editing an existing Contact
1. Press
CALL
LOCK
to enter the CALL Menu.
2. Rotate the Channel knob or press the keys to cycle to the
SAVED option then press
MENU
F
to select.
3. Rotate the Channel knob or press the keys to cycle to the
desired contact.
4. Briey press
MENU
F
to toggle between Alpha and Ident modes. When
the desired eld is displayed, hold
MENU
F
to select it. One of the
characters will ash.