GME TX6600PRO - Page 79

TX6600PRO INSTRUCTION MANUAL
75
Set Channel To Key
Saves the selected channel and assigns it to a prespecied Recall Channel key.
1. Select the desired channel.
2. Press the programmed Set Channel To Key key. The selected channel
will be saved and assigned to a designated Recall Channel key.
NOTE: The specied Recall Channel key must also have been dened by the
dealer software.
To recall the channel, use the assigned Recall Channel key (as described below)
Recall Channel
Press the programmed Recall Channel key to immediately recall to a preset
channel. The recall channel may have been saved using the Set Channel To Key
option above or may have been preset by the dealer software.
Dial Selcall
Press the programmed Dial SelCall key to immediately make a SelCall to
a predened SelCall contact on the selected channel. The SelCall contact is
predened using the dealer software.
Recall/Dial Selcall
Press the programmed Recall/Dial SelCall key to switch to a predened channel
and transmit a SelCall to a predened SelCall contact. The radio will stay on
the channel to listen for a response. The channel and the SelCall contact are
predened using the dealer software.
Redial Selcall
Press the programmed Redial SelCall key to automatically resend the last-sent
SelCall Ident on the selected channel.
Roger Beep Toggle
Press the programmed Roger Beep Toggle key to toggle the Roger Beep
function ON or OFF.
• Select ON to enable the Roger Beep feature.
• Select OFF to disable the Roger Beep feature.