GME TX6600PRO - Page 80

TX6600PRO INSTRUCTION MANUAL
76
When Roger Beep is ON a two-tone beep will be heard by the receiving station at
the end of your transmission to indicate that it is their turn to speak.
Roger Beep Menu
1. Press the programmed Roger Beep Menu key to access the Roger
Beep menu.
2. Rotate the Channel knob or press the keys to switch the
Roger Beep function ON or OFF.
• Select ON to enable the Roger Beep feature.
• Select OFF to disable the Roger Beep feature.
3. Press the
MENU
F
key to exit or wait a few seconds for the menu to time-out.
RSSI
1. Press the programmed RSSI key to temporarily display the incoming
signal strength in dBm in the area below the channel display.
2. Press any key to return to the normal display.
Scan
1. Press the programmed Scan key to start the Scan function.
2. While scanning, press the programmed Scan key again to stop the
Scan function. The radio will return to normal operation.
For more details on scanning, please refer the section on Scanning in the User
Manual.
Scan Hold
Press the programmed Scan Hold key while scanning has paused on a busy
channel to stay on the channel.
Scan Resume
Press the pre-programmed Scan Resume key while paused on a busy channel to
resume scanning.
This function can also be duplicated by rotating the Channel knob or pressing .
Scan Remove
Press the programmed Scan Remove key while scanning has paused on a busy
channel to remove the channel from the scan.