PROGRAMMING THE DOOR PANEL
P OUTPUT TIME
C 1P CODE
R3 OUTPUT TIME
P OUTPUT MODE
P OUTPUT TIME
6789
R3 OUTPUT TIME
P OUTPUT MODE
C 1 CODEP
C 1 MODEP
P OUTPUT MODE
P OUTPUT TIME
Determines whether the P1 button (located on the N3301/AL module) is
activated with the CP1 or CP2 code or always remains activated. So
that it is possible to restrict access to output activation buttons P1 and
P2 using the code configured in CP1 CODE. To change, press
.
C 1 MODEP
C 1 TIMEP
P OUTPUT TIME
C 1 CODEP
Determines the time in seconds that the output associated with the P1
button (relay R1) will remain activated.
To change the time, press and the message ENTER VALUE will
appear; enter the time to be assigned to the output and confirm by
pressing .
Press the button to restore the previous value.
ENTER VALUE
:03
1 0
C 1 MODEP
C 1 TIMEP
P OUTPUT TIME
C 1 CODEP
C 1 MODEP
10s
P OUTPUT TIME
C 1 CODEP
C 1 TIMEP
Cp2 CODE
C 1 CODEP
C 1 MODEP
Enables the code to activate or deactivate the P1 or P2 button to be
changed depending on the configuration of CP2 MODE.
To change, press and the message ENTER VALUE will appear; enter
the CP2 code using the numeric keypad and confirm by pressing .
Press to restore the previous value.
The code must have the same number of digits as the previous one,
between 4 and 6, depending on the NUMBER OF DIGITS value
configurable from the SYSTEM SETTINGS menu. The factory
setting is 4.
ENTER VALUE
:2222
4 52 3
C 1 TIMEP
C 2 CODEP
C 1 CODEP
C 1 MODEP
C 1 TIMEP
2345
C 1 CODEP
C 1 MODEP
C 2 CODEP
C 2 MODEP
C 1 MODEP
C 1 TIMEP
Determines whether the P2 button (located on the N3301/AL module) is
activated with the CP1 or CP2 code or always remains activated. So
that it is possible to restrict access to output activation buttons P1 and
P2 using the code configured in CP2 CODE.
To change, press
.
138
Access control menu
Continued from previous page
AUDIO AND VIDEO DOOR ENTRY SYSTEM - CODED PANEL WITH DISPLAY
Continued overleaf
To Next Page
Loading...
