Step 1: Place the battery vertically.
Step 2: Install the bracket on the bottom of the battery, and then remove the handles from the
battery.
Step 3: Install another bracket on the battery.
Step 4: Use screws to tight the brackets, then place the battery flatly.
Step 5: Stack multiple batteries.
Insert locating pin on the bracket into locating hole.
LX A5.0-10: Rack-mounted Installation
It is recommended to use a 19-inch standard rack with physical length and width of
600*800mm and above. The height can be chosen according to the number of batteries
in parallel.
For rack-mounted installation, electrical labels and warning labels need to be attached to
any position of the front panel of the battery (these labels are shipped as additional
accessories).
Step 1: Stick the electrical label and warning label to the position of the front panel of any battery.
Step 2: Place the battery on the guide rail of the rack and secure the battery to the rack with screws
from the handle.
To Next Page
Loading...
