DP752/DP730/DP722 Administration Guide
Version 1.0.11.4
Shows Device ID in hexadecimal format. This is needed by network administrators
for troubleshooting. The MAC address will be used for provisioning and can be
found on the label on original box and on the label located on the bottom panel of
the device.
Indicates used IP address mode: DHCP, Static IP or PPPoE.
Displays assigned IP address. Example: 192.168.5.110
Displays assigned subnet mask.
Example: 255.255.255.0
Displays assigned default gateway.
Example: 192.168.5.1
Indicates PPPoE connection status.
Shows assigned Primary DNS server address. Example: 8.8.8.8
Shows assigned Secondary DNS server address. Example: 8.8.4.4
Indicates type of NAT for each Profile. (Based on STUN protocol.)
Displays product model info. Default is DP752.
Shows product part number. Example: 9610006512A (last 2 digits show HW
version, in this example 12A for HW version 1.2A)
• Firmware Status: Displays the status of the firmware loaded.
• Boot: Specifies Boot version.
• Core: Specifies Core version.
• Base: Specifies Base version.
• Prog: Specifies Prog version. This is the main firmware release number,
which is always used for identifying the software system of the DP752.
• Locale: Specifies Locale version.
• Recovery: Specifies Recovery version.
• Handset: Specifies Handset firmware version.
Indicates system uptime since last reboot.
Shows actual time and date according to your configuration.
Reveals status of VoIP applications.