Notes:
• 8 levels are supported. Level 8 is the highest level. Level 5 is the default.
• appears when silent mode is enabled. In this mode no ring will be played for incoming calls.
Figure 22: Ringer Volume
Setting the Ringtones on the WP810
You can change the ringer melody for an incoming call. The device has different ringer melodies and in
order to configure the desired melody, proceed as follows:
1. Press Menu to bring up operation menu.
2. Use arrow keys to reach Settings → Basic Settings, and then select Sound tab.
3. Go to “Default Ringtone”, and choose the desired ringtones, press “Save” to confirm the ringtones
selected and the new ringtones will be set successfully.
Figure 23: Calls Default Ringtone
Date and Time
On the WP810 the Date and time are displayed on the idle screen and it obtains the date and time from the
Simple Network Time Protocol (SNTP) server by default. If your phone cannot obtain the date and time
from the SNTP server, you need to configure the date and time manually. You can configure the time format
and date format respectively. The handset supports two formats for time (12 Hour or 24 Hour) and three
date formats (DD/MM/YYYY; MM/DD/YYYY; YYYY/MM/DD).
To configure date and time manually
To Next Page
Loading...
