GRAPHTEC CE2000-60 - Page 12

x
6. USING APPLIED FUNCTIONS
6.1 Rotating the Coordinate Axes .......................................................................................... 6-2
6.2 Using the COPY Function ................................................................................................ 6-3
6.3 Enabling the AUTO PRE FEED Mode............................................................................ 6-5
6.4 Adjusting the Distance Precision ..................................................................................... 6-6
6.5 Aligning the Coordinate Axes........................................................................................... 6-7
6.6 Specifying the Page Length ............................................................................................. 6-9
6.7 Specifying the PLOT AREA ............................................................................................. 6-10
6.8 Expanding the Width of the Plot Area ............................................................................ 6-12
7. USING THE EXTENDED FUNCTIONS
7.1 Specifying the PEN UP SPEED ...................................................................................... 7-2
7.2 Specifying the OFFSET FORCE...................................................................................... 7-3
7.3 Specifying the OFFSET ANGLE ...................................................................................... 7-4
7.4 Selecting the STEP PASS ............................................................................................... 7-5
8. USING THE SPECIAL FUNCTIONS
8.1 Description of the Special Functions............................................................................... 8-2
8.2 Specifying the Special Functions..................................................................................... 8-4
9. TROUBLESHOOTING PROCEDURES
9.1 Printing a List of the Currently Selected Conditions ..................................................... 9-2
9.2 Running a SELF TEST..................................................................................................... 9-4
9.3 Using the DUMP Mode..................................................................................................... 9-5
9.4 Cutting the Demo Pattern................................................................................................. 9-7
9.5 The Plotter is Turned On But Doesn’t Operate ............................................................. 9-8
9.6 Mechanical Error Messages and Their Causes ............................................................. 9-8
9.7 Command Error Messages and Their Causes ............................................................... 9-9
9.8 The Cutting Results are Unsatisfactory .......................................................................... 9-12
APPENDIX
A.1 Main Specifications ........................................................................................................... A-2
A.2 Options and Supplies........................................................................................................ A-3
A.3 External Dimensions ......................................................................................................... A-4
A.4 Menu Tree ......................................................................................................................... A-6
INDEX................................................................................................................................................. I-1