6 – 8
Step 6
ADJ. PT 2
( 0, 0)
Use the POSITION keys to move the cutter pen to the desired ADJ. PT 2 position (any position along
the X axis of the initially plotted figure). The coordinate values displayed at such time represent the
relative distances from the ADJ. PT 1 position.
After the cutter pen is at the desired position, press the
ENTER
key to initiate calculation of the angle
of the tilt of X axis and to re-align the coordinate axes.
Step 7
Press the
PAUSE
key to cancel the PAUSE mode.
The AXIS ADJ. function
ADJ. PT 2
(any point along
the plotted X axis)
X
Y
The uncut area
The effective area before axis re-alignment
ADJ. PT 1
(the origin of
the initial plot)
The plotted X axis
NOTE : After setting the AXIS ADJ. settings, the settings become invalid when you perform any
of the following:
• Specify a new origin;
• Load new film; or
• Change the ROTATE setting to ON.
To Next Page
Loading...
