9 – 10
Error message Cause Solution
→ Configure the software to
drive your plotter.
Ensure that the software’s
interface conditions are cor-
rectly set.
→ Ensure that the plotter’s in-
terface conditions are set
to match those of the soft-
ware.
→ Configure the software to
drive your plotter.
Ensure that the software’s
interface conditions are cor-
rectly set.
→ Ensure that the plotter’s in-
terface conditions are set
to match those of the soft-
ware.
→ Configure the software to
drive your plotter.
Ensure that the software’s
interface conditions are cor-
rectly set.
→ Ensure that the plotter’s in-
terface conditions are set
to match those of the soft-
ware.
A command was received with an
incorrectly specified delimiter.
• The software configuration regard-
ing the output device has been
changed.
• The plotter’s interface conditions
have been changed.
A command was received containing
a numeric parameter that exceeds
that command’s permissible range.
• The software configuration regard-
ing the output device has been
changed.
• The plotter’s interface conditions
have been changed.
An error occurred during data trans-
fer.
• The software configuration regard-
ing the output device has been
changed.
• The plotter’s interface conditions
have been changed.
ERROR 3
DELIMITER ERROR
ERROR 4
PARAMETER OVERFLOW
ERROR 5
I/O ERROR
Error messages in GP-GL command mode
(2/2)
To Next Page
Loading...
