I – 1
INDEX
A
AC power cord ................................................ 1-2
AC power inlet.......................................... 1-3, 1-5
Accessories..................................................... 1-2
Adjusting the blade length............................. 2-13
Adjusting the registration-mark reading
sensor (1)................................................... 4-16
Adjusting the registration-mark reading
sensor (2)................................................... 4-17
Aligning the coordinate axes......................... 4-20
Aligning the push rollers.................................. 2-9
An error message was displayed.................... 6-4
Assembling the stand...................................... 1-7
Attaching the basket ..................................... 1-10
AUTO PRE-FEED........................................... 4-4
Auto-registration-mark-reading settings.......... 4-6
B
Basket attachment instructions ..................... 1-10
Blade-tip initial position setting........................ 5-2
C
Checking the wear rate ................................. 4-34
Circle-command resolution setting.................. 5-3
Clearing the buffer memory .......................... 4-19
Clearing the total distance (wear rate) .......... 4-36
COND. ............................................................ 1-6
Condition-list printing .................................... 4-39
Connecting to your computer.......................... 2-2
Control panel................................................... 1-6
Cutter blade (CB09UA) ................................... 1-2
Cutter plunger ................................................. 1-2
Cutter-pen construction................................. 2-12
Cutting demo................................................. 4-41
Cutting mat............................................... 1-3, 1-4
Cutting/plotting using the buffer memory (COPY
function) ..................................................... 4-28
D
Description of special functions ............... 5-2, 5-4
Display language setting................................. 5-4
Displaying the effective cutting area ............... 3-9
Distance adjustment ..................................... 4-22
Drawing origin point ........................................ 4-9
Dump mode ...................................................4-40
E
Enabling/disabling blade wear detection .........5-3
Enabling/disabling PEN UP MOVE..................5-3
Enabling/disabling the “:” and “;”
commands ....................................................5-2
Enabling/disabling the home sensors..............5-3
Enabling/disabling the media sensors .............5-3
ENTER.............................................................1-6
Error messages in GP-GL command mode.....6-5
Error messages in HP-GL command mode.....6-6
Expanding the cutting/plotting area ...............4-26
External dimensions ....................................... A-4
G
GP-GL ERROR................................................6-5
Grit roller.................................................. 1-3, 1-4
H
HP-GL ERROR................................................6-6
I
Indicator lamp ..................................................1-6
Interface settings ...........................................4-31
L
Loading the medium ........................................2-4
Loading the roll medium ..................................2-6
Loading the Roll Medium on the Roll-Medium
Trays (CE3000-40/60) ..................................2-4
M
Main specifications ......................................... A-2
Media cutter.....................................................1-2
Media set lever ........................................ 1-3, 1-4
Medium and registration-mark position............4-8
Menu tree........................................................ A-6
Model ID response...........................................5-2
Moving the pen ................................................3-9
Moving the pen carriage in +100 mm
steps ...........................................................3-11
To Next Page
Loading...
