3 – 10
Moving the origin when the coordinate axes have been rotated gives the following results.
When the coordinate axes are rotated after the origin point is moved, the origin point is reset as shown in
the figure below. The distance “a” is retained, but the distance “b” is reset.
When it is necessary to both move the origin and rotate the coordinate axes, be sure to rotate the coordi-
nate axes first.
3.7 Stop Function
Cutting or plotting can be stopped by pressing the (PAUSE) key while cutting or plotting is in progress.
The operation selection menu is displayed on the control-panel screen while cutting or plotting is stopped,
enabling operations to be resumed or aborted as required. Raising or lowering the media set lever while
the cutting or plotting is stopped does not require the medium to be selected, so the medium can be
replaced or reset.
Press the (PAUSE) key while cutting or plotting is in progress to stop cutting or plotting and display the
PAUSE menu.
When the Origin is Moved After Rotating the Coordinate Axes
When the Coordinate Axes are Rotated After Moving the Origin Point
After a new origin point is set, the displayed coordinate values of X= and Y= repre-
sent the respective distances from the new origin.
Step
1
Original origin
New origin
X
Y
a
Origin moved
a
b
b
Origin moved
after rotation
X
Y
Y
X
Original origin
Origin moved
Original origin
Origin moved Rotation
CHECKPOINT
FEED
To Next Page
Loading...
