4 – 36
■ Setting Wear-Rate Factors
This sets factors corresponding to the differences in wear rates due to different materials and cutting con-
ditions.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the wear-rate setting submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the wear-rate factor setting.
Use the and keys to increase or decrease the setting-area number, and use the and keys
to increase or decrease the factor value. The factor can be set to between 0.10 and 1.00 in 0.10 intervals,
and between 1.00 and 2.50 in 0.25 intervals. Once the wear-rate factor is set, press the (ENTER) key
to confirm. To cancel, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
■ Clearing the Total Distance (Wear Rate)
Always zero the total-distance display when a cutter blade has been replaced. This starts the total-distance
calculation from zero.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
Step
1
Step
2
BLADE WEAR SETUP
FACTOR
COND 1 1.00
BLADE WEAR SETUP
To Next Page
Loading...
