2 – 8
■ Loading Sheet Media
Lower the media set lever to raise the push rollers.
With the CE3000-40/60, position the edges of the medium flush against the guide lines engraved on the
front guide. With the CE3000-120, load the medium, aligning the edges with the upper and lower scales on
the front guide.
Adjust the position of the left- and right-hand push rollers to suit the medium width.
Raising the media set lever displays a menu for selecting the media mode. Select the media mode.
Step
1
Step
2
Step
3
Step
4
If the “REALIGN ROLLERS” message is displayed when the medium is loaded
and the media set lever is raised, either the right-hand push roller is not positioned
over the right-hand wide grit roller, or the left-hand or center (CE3000-120) push
rollers are not positioned over the grit roller. Check to confirm that they are posi-
tioned correctly.
Guide lines
Media sensor
Flush
CE3000-40/60
Align with scale
Media sensor
CE3000-120
SHEET PRESS ENTR
CHECKPOINT
To Next Page
Loading...
