4 – 24
4.9 Setting the PAGE LENGTH
This function sets the length of each page when long-axis cutting or plotting is performed using a roll
medium. This should be set for long-axis cutting or plotting exceeding 5 m in length. The default setting is
“5000 mm.“
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the page-length menu.
Move the cursor to the digit to be changed using the and keys. Use the
and keys to increase or decrease the setting, and then press the (ENTER)
key to confirm. To cancel, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
1
Step
2
Step
3
Step
4
• This setting is retained in the memory even when the
power is turned off.
• The cutting plotter’s distance precision is guaranteed for
page-feed lengths of up to 5 meters, provided that the
following conditions are satisfied (CE3000-60/120).
Long-axis cutting over 5 meters is possible for lengths of
up to 50 meters in the feeding direction.
Guaranteed precision conditions:
–The cutting plotter is mounted on its stand.
–Graphtec-specified film is used with the stipulated set-
ting conditions.
Film: 3M plastic-backed film
Setting conditions: Cutter speed, 30 cm/s max; Quality,
1
• In the case of long-axis cutting, be particularly careful
when loading color adhesive-backed film. If the film is
loaded at even a slight angle, the film may come loose
from the rollers that hold it in place.
• For long-axis cutting using roll media, pull out the length
of the medium to be used, or use the pre-feed operation
(see “4.2 Setting the FEED function” and “4.3 Setting
AUTO PRE-FEED”).
FEED
AUTO PRE FEED
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
EXPAND
ROTATE
COPY
SORT
RS-232C
COMMAND
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
PEN UP SPEED
OFFSET FORCE
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
PAGE LENGTH
L=05000mm
CHECKPOINT
To Next Page
Loading...
