GRAPHTEC CE3000-40 - Moving the Pen Carriage in +100 MM Steps

3 – 11
Pressing the (PAUSE) key while cutting or plotting is stopped cancels the pause function and restarts
cutting or plotting. To completely abort cutting or plotting, stop sending data from the computer or press the
(NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the buffer memory clear menu.
Press the or key to select “YES” or “NO.” To abort cutting or plotting, select “YES” and press the
(ENTER) key. To cancel, select “NO” and either press the (ENTER) key or press the (NEXT) or
(PREV.) key.
Press the (PAUSE) key to reset PAUSE mode.
3.8 Moving the Pen Carriage in +100 mm Steps
This function allows the pen carriage to be moved from its current position in +100 mm steps along the X-
and Y-axes.
In READY mode, press the key while holding down the (ENTER) key to move the pen carriage in
+100 mm steps along the X- and Y-axes.
In READY or PAUSE mode, press the key while holding down the (ENTER) key to return the pen
carriage to the origin.
Step
2
Step
3
Step
4
Step
5
Returning to the original position
CLEAR BUFFER
CLEAR <YES>
Original pen-carriage position
Moved pen-carriage
position
Y
X
100mm
100mm