2 – 6
Lower the media set lever to raise the push rollers.
Place the roll medium on the roll-medium trays or stand stock rollers, and then pass the leading edge of
the medium from the back of the cutting plotter so it emerges from the front, while making sure to remove
any slack in the medium conveyance path.
Pull the leading edge out of the front of the cutting plotter so that it completely covers the media sensor. If
the leading edge has been pulled out too far, turn the roll to adjust the length of the medium that is protrud-
ing.
Adjust the position of the left- and right-hand push rollers to suit the width of the roll medium.
Loading the Roll Medium
Step
1
Step
2
Step
3
Load the medium so that it passes over the media sensor.
Step
4
Media sensor
CHECKPOINT
To Next Page
Loading...
