4 – 41
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the test-mode submenu, and press the (NEXT) or (PREV.)
key until the following menu is displayed.
Press the (ENTER) key to switch to dump mode.
When data is sent to the cutting plotter in this mode, a dump list is printed out. To exit the dump mode, turn
on the power again.
■ Cutting Demo
This function cuts a cutting-demo pattern.
Mount a plotting pen in the pen carriage, and set the conditions to suit the pen used (e.g., force, pen speed
settings).
Load a film for cutting.
Press the (PAUSE) key to switch to PAUSE mode.
Step
3
Step
4
Step
5
Step
6
Step
7
The dump list is printed out as ASCII character codes. Characters without codes
will be printed as small 2-digit figures. Output data for READ-type commands will
be output as dummy data, except for cutting-plotter status output.
The pen carriage begins moving as soon as this function is set. Keep your hands and
other objects away from the cutting plotter’s moving parts.
Step
1
Step
2
Step
3
TEST MODE
DUMP
CHAR DUMP MODE
CHECKPOINT
To Next Page
Loading...
