4 – 26
4.11 Expanding the Cutting/Plotting Area
This function allows the width of the cutting/plotting area to be extended by 9.5 mm on both sides, for a
total increase of 19 mm, enabling cutting to be performed up to the area in which the pinch rollers are posi-
tioned.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the plotting-area width-setting menu.
Press the or key to select “ON” or “OFF,” and then press the (ENTER)
key to confirm. To cancel, press the (NEXT) or (PREV.) key.
If the settings are not changed, press the (PAUSE) key to cancel PAUSE
mode. If the settings are changed, the media-type selection menu is displayed.
For details on the media loading and selection procedures, refer to “2.3 Loading
the Medium.”
The following message is displayed if the lower-left and upper-right settings are not
separated by a distance of at least 5 mm. If this message appears, reset the lower-
left and upper-right positions.
Step
1
Step
2
Step
3
Step
4
Step
5
CHECKPOINT
WRONG PLOT AREA
FEED
AUTO PRE FEED
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
EXPAND
ROTATE
COPY
SORT
RS-232C
COMMAND
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
PEN UP SPEED
OFFSET FORCE
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
EXPAND
EXPAND OFF
ROLL2 PRESS ENTR
To Next Page
Loading...
