4 – 33
Press the (ENTER) key to display the step-size setting menu.
Use the and keys to select “0.100 mm,” “0.050 mm,” “0.025 mm,” or “0.010 mm,” and then press
the (ENTER) key to confirm. To cancel the selection, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
■ Setting the ORIGIN POINT
If the HP-GL command mode is set, the origin point can be set to the lower left or center. The default set-
ting is the lower left, so change this setting if your application specifies a different origin position.
Set the command setting to “HP-GL.”
Press the (ENTER) key to display the origin-point setting.
Press the or key to select “L.L. (LOWER LEFT)” or “CENTER,” and then press the (ENTER)
key to confirm. To cancel the selection, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
2
Step
3
Step
4
Step
1
Step
2
Step
3
Step
4
STEP SIZE 0.100mm
COMMAND HP-GL
ORIGIN PT L.L.
To Next Page
Loading...
