2 – 12
■ Cutter-Pen Construction
The cutting plotter cuts using a cutter blade mounted in a cutter-pen plunger. There are two different cutter-
pen plungers to suit the diameter of the cutter blade to be mounted (the 0.9-mm cutter-pen plunger is pro-
vided as standard equipment). Be sure to mount the cutter blade in the corresponding cutter-pen plunger.
■ Replacing the Cutter Blade
Turn the blade-length adjustment knob to retract the blade into the plunger.
Turn the plunger cap in the counter-clockwise direction to remove it from the plunger.
Remove the blade from inside the plunger cap.
Insert the new blade into the hole provided in the plunger cap.
To prevent cutting your fingers, always handle the cutter blade with caution.
Step
1
Step
2
Step
3
Step
4
Cutter blade
Plunger cap
Plunger
Blade-length adjustment knob
(Blue: For 0.9-mm-diameter blades)
(Red: For 1.5-mm-diameter blades)
CAUTION
1.5-mm-diameter cutter pen
Plunger-cap
cross-section
Plunger cap
1.5-mm-dia. blades
Blade-length
adjustment knob (red)
Plunger
Spring
Plunger cap
Plunger-cap
cross-section
0.9-mm-dia. blades
0.9-mm-diameter cutter pen
Blade-length
adjustment knob (blue)
Plunger
To Next Page
Loading...
