4 – 22
4.8 Distance Adjustment
This function corrects any deviation in the length of cut or the plotted line segments, which occurs depend-
ing on the medium being used. The adjustment value for the deviation is specified as a percentage of the
total distance. For example, a setting of 0.05% adjusts a distance of 2 m (2,000 mm) by +1 mm (2000 x
0.05% = 1 mm), to become 2,001 mm. Eight different cutter-pen condition-setting areas can be set on or
off separately, allowing different settings to be made in order to suit the medium used.
Press the
(PAUSE) key
to switch to PAUSE mode.
Press the
(NEXT)
or
(PREV.) key
until the following menu is displayed.
Press the
(ENTER) key
to display the distance adjustment menu. The num-
bers
“1”
to
“8”
indicate the cutter-pen condition-setting areas, and those that are
set on are indicated with the symbol to the left.
Move the cursor to select the required condition-setting area using the
and
keys
. Press the
or
key
to display or not display the symbol, and then
press the
(ENTER) key
to confirm. To cancel, press the
(NEXT)
or
(PREV.) key
.
Press the
(PAUSE) key
to cancel PAUSE mode.
Select the condition-setting area to be set to
“ON”
(refer to “Selecting Cutter-Pen-
Condition Setting Areas” on page 3-6).
Either press the
(ENTER) key
or use the key to move the cursor to the far
right, and then press the key to display the following menu.
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
FEED
AUTO PRE FEED
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
EXPAND
ROTATE
COPY
SORT
RS-232C
COMMAND
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
PEN UP SPEED
OFFSET FORCE
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
DISTANCE ADJUST
1 2 3 4 5 6 7 8
5 15U 0 20 30 1
X= 0.00%Y= 0.00%
To Next Page
Loading...
