GRAPHTEC CE3000-40 - 4 FUNCTION SETTINGS AND OPERATIONS

4
4
FUNCTION SETTINGS AND OPERATIONS
4.1 PAUSE Menu List ........................................................................4-2
4.2 Setting the FEED function.......................................................4-3
4.3 Setting AUTO PRE-FEED .........................................................4-4
4.4 Setting TANGENTIAL Mode.....................................................4-5
4.5 Auto-Registration-Mark-Reading Settings
(Factory Option)...............................................................................4-6
4.6 Clearing the Buffer Memory..................................................4-19
4.7 Aligning the Coordinate Axes..............................................4-20
4.8 Distance Adjustment...............................................................4-22
4.9 Setting the PAGE LENGTH ....................................................4-24
4.10 Setting the Cutting/Plotting Area........................................4-25
4.11 Expanding the Cutting/Plotting Area.................................4-26
4.12 Rotating the Coordinate Axes..............................................4-27
4.13 Cutting/Plotting Using the Buffer Memory
(COPY Function)............................................................................4-28
4.14 Sorting Settings ........................................................................4-30
4.15 Interface Settings .....................................................................4-31
4.16 Setting the Format of Data to be Received .....................4-32
4.17 Blade Wear Detection (When Blade Wear Setup is On) ......4-34
4.18 Raising and Lowering the Pen.............................................4-38
4.19 TEST Mode..................................................................................4-39
4.20 Setting the PEN UP SPEED...................................................4-43
4.21 Setting the OFFSET FORCE (Initial Cutting Force) ..........4-44
4.22 Setting the OFFSET ANGLE .................................................4-45
4.23 Setting the STEP PASS...........................................................4-46
4.24 Setting the Initial Down Force..............................................4-47
4.25 Setting the LENGTH UNIT......................................................4-48