GRAPHTEC CE3000-40 - 2.3 Loading the Medium

2 – 4
If no medium has been loaded, the message below appears on the display, prompting the loading of a
medium.
If a medium has already been loaded, the current media setting is displayed as shown below.
Select the media mode to suit the medium used. For instructions on loading media and selecting the media
mode, see “2.3 Loading the Medium.”
2.3 Loading the Medium
Load the medium, aligning it with the right-hand grit roller when viewed from the front so that it registers
with the media sensor. Then, adjust the push-roller position to match the width of the medium. The cutting
plotter can use media in roll or sheet form. Load the desired medium type by following the appropriate
instructions.
■ Loading a Roll Medium
Load the roll medium onto the roll-medium trays or stand stock rollers.
Place the roll-medium trays flush against the roll-medium-tray guide rail, and place the roll medium on top
of them. Make sure the roll-medium trays are set on the correct side with the bearings facing outward.
Step
4
The roll-medium trays are provided as standard equipment with the CE3000-40/
60, but cannot be used with the CE3000-120. The stand is provided as standard
equipment with the CE3000-120 and is available as an option with the CE3000-60,
but cannot be used with the CE3000-40.
Loading the Roll Medium on the Roll-Medium Trays (CE3000-40/60)
Step
1
LOAD MEDIA!!
ROLL2 PRESS ENTR
CHECKPOINT
Roll-medium trays
Roll-medium-tray
guide rail
Flush
Roll medium