GRAPHTEC CE3000-40 - Setting QUALITY; Setting SPEED

3 – 8
Press the or key to select the value to be changed in the range specified below.
CE3000-40/60: “1” to “31”
CE3000-120: “1” to “38”
Once set, press the (ENTER) key. If other conditions are to be set, press the or key to move
the symbol to the parameter to be set.
■ Setting SPEED
Sets the speed used for cutting. Set the SPEED value based on the guidelines in the table entitled “Opti-
mal Cutting Conditions for Each Media Type” on page 3-5.
Press the (COND.) key in READY mode to display the cutter-pen conditions.
Select the setting area (condition number) to be set, and move the symbol to the position shown below
using the or key.
Press the or key to select the value to be corrected in the range specified below.
CE3000-40: “1” to “40”
CE3000-60: “1” to “60”
CE3000-120: “1” to “60”; “*”
For all cutting plotters, “1” to “10” is in increments of 1, and “10” to “40” or “60” is in increments of 5.
Once set, press the (ENTER) key. If other conditions are to be set, press the or key to move
the symbol to the parameter to be set.
■ Setting QUALITY
Sets the acceleration used in cutting
Press the (COND.) key in READY mode to display the cutter-pen conditions.
Select the setting area (condition number) to be set, and move the symbol to the position shown below
using the or key.
Step
3
Step
1
Step
2
Step
3
Selecting “*” for the CE3000-120 sets the maximum speed. QUALITY is also set to
“*”, and the acceleration of the cutter is calculated automatically.
Step
1
Step
2
2 09U +1 23 30 2
CHECKPOINT
2 09U +1 23 30 2