1 – 3
1.2 Parts Names and Functions
■ Front View (CE3000-40/60)
Cutting mat : Cutting or plotting is performed on this mat.
Grit roller : Feeds the medium backward or forward
Push rollers : Pushes the medium against the grit rollers
Pen carriage : Moves the cutter pen to the left and right
Pen holder : Holds the cutter pen and moves it up and down
Media set lever : Raises or lowers the push rollers during loading of a medium
Control panel : Used to operate the cutting plotter and set functions
Parallel (Centronics) interface connector : Used to connect a Centronics-compatible parallel interface cable
USB interface connector : Used to connect a USB cable
Serial (RS-232C) interface connector : Used to connect an RS-232C serial interface cable
■ Rear View (CE3000-40/60)
Roll-medium trays : Holds a roll medium
Roll-medium-tray guide rail : Used to mount the roll-medium trays
AC power inlet : Connects the power cord to the cutting plotter
Power switch : Turns the power supply to the cutting plotter on or off
Cutting mat
Grit roller
Pen carriage
Push rollers
Media set leverPen holder
USB interface
connector
Serial (RS-232C)
interface connector
Control panel
Parallel (Centronics)
interface connector
AC power inlet
Power switch
Roll-medium trays
Roll-medium-tray
guide rail
To Next Page
Loading...
