GRAPHTEC CE3000-40 - 4.5 Auto-Registration-Mark-Reading Settings (Factory Option)

4 – 6
Press the (ENTER) key or move the cursor to the right-hand side using the key, and then press the
key again to display the menu shown below. If the distance adjustment is set for the setting area
selected, the distance adjustment will be displayed here. Either press the (ENTER) key or move the
cursor to the right-hand side and press the key.
Use the and keys to select “Mode 1” or “Mode 2,” and then press the (ENTER) key. The over-
cut setting is displayed.
“STR” indicates the initial overcut amount, and “END” indicates the end overcut amount for the line sec-
tion. Select “STR” or “END” using the or key, use the and keys to increase or decrease
the values, and then press the (ENTER) key to confirm. To cancel, press the (NEXT) or
(PREV.) key.
4.5 Auto-Registration-Mark-Reading Settings (Factory Option)
These settings enable pre-plotted media to be cut without any offset by reading the registration marks
using the cutting-plotter sensor and adjusting the axes to suit the coordinate data.
The following precautions must be observed when the registration marks are automatically read.
• Registration-mark pattern
• Reading range required for the detection of registration marks
• Medium and registration-mark position
• Drawing origin point
• Medium type
Step
6
Step
7
Step
8
Registration-mark reading accuracy *: Within 0.3 mm
* Accuracy when using pens provided with the cutting plotter, high-grade media,
and reading the specified pattern.
TANGENTIAL MODE 1
STR=0.2 END=0.2
CHECKPOINT
Sensor