GRAPHTEC CE3000-40 - Self-Test-Pattern Printing; Dump Mode

4 – 40
■ Self-Test-Pattern Printing
This function prints out a self-test pattern to check the accuracy of the cutting plotter.
Mount a plotting pen in the pen carriage, and set the conditions to suit the pen used (e.g., force, pen speed
settings).
Load an A3-size or larger medium.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the test-mode submenu, and press the (NEXT) or (PREV.)
key until the following menu is displayed.
Press the (ENTER) key to start printing the self-test pattern.
When the self-test pattern has been printed, turn on the power again.
■ Dump Mode
This function checks whether data is sent correctly from the computer. If the output data does not match
the program after the dump list has been output, check the transfer conditions and connections.
Mount a plotting pen in the pen carriage, and set the conditions to suit the pen used (e.g., force, pen speed
settings).
Load an A4-size or larger medium.
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
Step
7
The pen carriage begins moving as soon as this function is set. Keep your hands and
other objects away from the cutting plotter’s moving parts.
Step
1
Step
2
TEST MODE
SELF TEST
CAUTION