GRAPHTEC CE3000-40 - 3.6 Setting the Initial Cutting Position (Origin Point)

3 – 9
Press the or key to select the value to be changed in the range specified below
CE3000-40: Fixed to “1”
CE3000-60: “1”, “2”, “3”
CE3000-120: “1”, “2”, “*”
Once set, press the (ENTER) key. If other conditions are to be set, press the or key to move
the symbol to the parameter to be set.
3.4 Displaying the Effective Cutting Area
Press the (ENTER) key in READY mode to display the current effective cutting area.
3.5 Moving the Pen
In READY mode, press the or key to move the pen carriage to the left or right, and the or
key to feed the medium backward or forward.
3.6 Setting the Initial Cutting Position (Origin Point)
This function allows the starting position for cutting or plotting to be moved to the desired position.
In READY mode, press the , , , and (POSITION) keys to move the cutter pen to the new ori-
gin point.
Press the (ORIGIN) key. The following menu is displayed and the new origin is set.
Step
3
• If SPEED is set to “*” for the CE3000-120, QUALITY is also set to “*” and accel-
eration is calculated automatically.
Step
1
Step
2
CHECKPOINT
X 0000mm Y 000mm
Original origin
New origin
Y
X
ORIGIN PT SET