viii
PREFACE
Thank you for choosing a Graphtec CE3000-series cutting plotter. The CE3000-40 cutting plotter uses
stepping motors, and the CE3000-60/120 employ a digital servo drive system to achieve high-speed and
high-precision cutting. In addition to cutting marking film and other media, it can also be used as a pen
plotter. To ensure high cutting quality and optimal productivity, be sure to read this User’s Manual thor-
oughly prior to use.
Notes on this Manual
(1) No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form
or by any means, without the prior written permission of Graphtec Corporation.
(2) The product specifications and other information in this manual are subject to change without notice.
(3) While every effort has been made to provide complete and accurate information, please contact your
sales representative or nearest Graphtec vendor if you find any unclear or erroneous information or
wish to make other comments or suggestions.
(4) Notwithstanding the stipulations in the preceding paragraph, Graphtec Corporation assumes no liabil-
ity for damages resulting from either the use of the information contained herein or the use of the
product.
Registered Trademarks
All names of companies, brands, logotypes, and products appearing in this manual are the trademarks or
registered trademarks of their respective companies.
Copyright
This User’s Manual is copyrighted by Graphtec Corporation.
To Next Page
Loading...
