I – 3
Test cutting ................................................... 3-12
TEST mode................................................... 4-39
The cutting plotter does not operate
correctly ....................................................... 6-2
The cutting plotter does not operate when
turned On..................................................... 6-2
The cutting results are unsatisfactory ............. 6-3
The initial down force .................................... 4-47
Troubleshooting .............................................. 6-1
Turn the blade-length adjustment ................. 2-12
Turning on the power ...................................... 2-3
Types and features of cutter blades.............. 2-11
U
USB interface connector .......................... 1-3, 1-4
User Guide CD-ROM ...................................... 1-2
W
Water-based fiber-tip pen ............................... 1-2
Wear detection.............................................. 4-34
Wear-rate groups .......................................... 4-35
To Next Page
Loading...
