GRAPHTEC CE3000-40 - Page 12

xi
4.19 TEST Mode..................................................................................................................... 4-39
Condition-List Printing ..................................................................................................... 4-39
Self-Test-Pattern Printing ................................................................................................ 4-40
Dump Mode..................................................................................................................... 4-40
Cutting Demo................................................................................................................... 4-41
4.20 Setting the PEN UP SPEED .......................................................................................... 4-43
4.21 Setting the OFFSET FORCE ......................................................................................... 4-44
4.22 Setting the OFFSET ANGLE ......................................................................................... 4-45
4.23 Setting the STEP PASS................................................................................................. 4-46
4.24 Setting the Initial Down Force...................................................................................... 4-47
4.25 Setting the LENGTH UNIT............................................................................................. 4-48
5. Setting and Using the Special Functions
5.1 Description of Special Functions A............................................................................... 5-2
Enabling/Disabling the “:” and “;” Commands
(when the COMMAND setting is GP-GL) .......................................................................... 5-2
Moving the Pen While Raised or Lowered in Response to the “W” Command
(when the COMMAND setting is GP-GL) .......................................................................... 5-2
Model ID Response (when the COMMAND setting is HP-GL).......................................... 5-2
SETTING PRIORITY ......................................................................................................... 5-2
Blade-Tip Initial Position Setting........................................................................................ 5-2
Enabling/Disabling PEN UP MOVE................................................................................... 5-3
Enabling/Disabling the Media Sensors.............................................................................. 5-3
Enabling/Disabling the Home Sensors.............................................................................. 5-3
Setting the PARALLEL I/F Mode....................................................................................... 5-3
Circle-Command Resolution Setting (when the COMMAND setting is HP-GL) ................ 5-3
Enabling/Disabling Blade Wear Detection......................................................................... 5-3
5.2 Setting Special Functions A........................................................................................... 5-4
5.3 Description of Special Functions B............................................................................... 5-4
Display Language Setting (MENU LANGUAGE SELECTION) ......................................... 5-4
5.4 Setting Special Functions B........................................................................................... 5-5
6. TROUBLESHOOTING
6.1 The Cutting Plotter Does Not Operate When Turned On............................................. 6-2
6.2 The Cutting Plotter Does Not Operate Correctly .......................................................... 6-2
6.3 The Cutting Results Are Unsatisfactory........................................................................ 6-3
6.4 An Error Message Was Displayed ................................................................................. 6-4
APPENDIX
Appendix A Main Specifications.........................................................................................................A-2
Appendix B Options and Supplies......................................................................................................A-3
Appendix C External Dimensions.......................................................................................................A-4
Appendix D Menu Tree.........................................................................................................................A-6
INDEX