GRAPHTEC CE3000-40 - Page 21

1 – 9
Mount the CE3000 cutting plotter on the stand by inserting the positioning pins on the stand into the posi-
tioning holes on the underside of the cutting plotter. Fasten using the four coin screws or hexagonal socket
bolts (M6).
Tighten the hexagonal socket bolts loosely fastened in step 3.
Step
4
With the CE3000-120, make sure the casters with stoppers are at the front.
Step
5
CE3000-60
CE3000-120
Coin screws
Stand
CE3000-60
cutting plotter
Positioning pins
Hexagonal socket
bolts (M6)
Positioning pins
Stand
CE3000-120
CHECKPOINT