GRAPHTEC CE3000-40 - Page 23

1 – 11
Mount the CE3000 cutting plotter on the stand by inserting the positioning pins on the stand into the posi-
tioning holes on the underside of the cutting plotter. Fasten using the four coin screws or hexagonal socket
bolts (M6).
Step
3
With the CE3000-120, make sure the casters with stoppers are at the front.
CE3000-60
CE3000-120
Stand
Hexagonal
socket bolts (M6)
CE3000-120
cutting plotter
Positioning pins
Coin screws
Stand
CE3000-60
cutting plotter
Positioning pins
CHECKPOINT