2 – 10
Position the push rollers over the grit rollers to grip each edge of the medium.
Position push rollers (1) and (3) over the grit rollers to grip each edge of the medium, and position push
roller (2) over the grit roller nearest the center of the medium. The medium is gripped by the three push roll-
ers (1), (2), and (3).
To move the push rollers, the media set lever must be in the lowered position.
If the “REALIGN ROLLERS” message is displayed when the medium is loaded
and the media set lever is raised, either the right-hand push roller is not positioned
over the right-hand wide grit roller, or the left-hand push roller is not positioned
over the grit roller. Check to confirm that they are positioned correctly.
For the CE3000-40/60
• The push roller (1) must be positioned over the right-hand wide grit roller.
• The medium must always be positioned over the media sensor.
For the CE3000-120
CAUTION
CHECKPOINT
Media sensor
Push roller (1)
Push roller (2)
Grit roller
Medium
OK OK
CAUTION
Push roller (1)
Push roller (2)
Push roller (3)
Grit roller
Media sensor
OK OK
NG NG
To Next Page
Loading...
