4 – 11
This sets the distance between the registration marks and changes the initial registration-mark scanning
position. Avoiding reading areas that obviously do not include registration marks increases the registration-
mark reading speed and minimizes the possibility of incorrect reading due to other marks on the medium.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the registration-mark detection movement distance X-axis setting.
Move the cursor to the digit to be entered using the and keys, use the and keys to increase
or decrease the values, and then press the (ENTER) key to confirm. The Y-axis setting is then dis-
played and should be set in the same way.
Setting the Registration-mark detection movement distance
Step
1
Step
2
Step
3
Step
4
Step
5
Registration-mark pattern 1
Medium feed direction
Registration-mark pattern 2
Set the registration-
mark detection
movement distance X
based on this distance.
Set the registration-
mark detection
movement distance X
based on this distance.
Set the registration-mark
detection movement distance
Y based on this distance.
Set the registration-mark
detection movement distance
Y based on this distance.
X
Y
AUTO REG. MARK
MARK POSITION
M. POS X=0000mm
To Next Page
Loading...
