Setting up The Cutter Plotter
2-5
Align the collar with the shaft holder, and then press down firmly on the collar until it is fully
seated.
CAUTION
• While cutting or plotting is in progress,
please keep your hands, hair, etc., away
from the shaft holder and the collar.
• Performing a cutting or plotting operation
when the stock shaft is seated at an angle
may cause malfunctions such as paper
shift to occur.
CollarShaft holder
Press down firmly
on the collar
Stock shaft
Confirm that the roll is correctly oriented.
NG
OK
(3) If you have not already done so, align the stoppers with the left and right edges of the roll
medium and then tighten the stopper screws.
(4) Lower the media set lever to raise the push rollers.
To Next Page
Loading...
