2-6
Setting up The Cutter Plotter
(5) Move the stock shaft stopper to the FREE position.
FREE position:
This is the status when the lever has been pushed down and engaged, and the silver-colored
section is hidden. The stock shaft rotates in the FREE status.
LOCKFREE
CAUTION
While cutting or plotting is in
progress, please keep your
hands, hair, etc., away from
the shaft holder and the collar.
Black sticker Silver-colored section
(6) Feed the leading edge from the back through to the front, making sure to remove any slack in
the medium while pulling it towards you.
Media sensor
CHECKPOINT
Load the medium so that it passes over the media sensor.
Pass the medium's leading edge over the center bar and around the outside of the alignment
shaft.
NG NG
OK
(7) Adjust the position of the left- and right-hand push rollers to suit the width of the medium.
(See "Aligning the Push Rollers" later in this section.)
To Next Page
Loading...
