111
Detail program description - Control adjust | Winged models
0%
+88%I5
I6
I7
I8
TYP
+100%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
Another brief tap on the center SET key of the right
touch pad will complete the entry.
Negative and positive parameter values are possible
in order to appropriately adapt the control's direction
or effect.
A simultaneous tap on the cd or ef keys of the
right touch pad (CLEAR) will reset the changed
parameter displayed in inverse video back to
"+100 %".
Important:
In contrast to servo travel settings, changing the
control travel setting affects all "downstream" mixer
and coupling inputs, i.e. any and all servos actuated
by the given transmitter control.
Column 6, "–time+"
Each of the function inputs 5 … 16 can be assigned
a symmetrical or asymmetric time delay of between 0
and 9.9 s.
Move the marker frame to the right beyond the
column labeled "– travel +" with the f selection key
of the left or right touch pad.
To set a symmetric, i.e. control-side independent,
time delay, the respective operating element
(transmitter control or switch) is to be put into a
position in which the time setting is covered on both
sides by the marker frame.
0%
+111%I5
I6
I7
I8
TYP
+111%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
To set an asymmetric time delay, move the given
transmitter control (proportional control or switch)
as necessary to the side to be set such that only the
value to be changed is covered.
0%
+111%I5
I6
I7
I8
TYP
+111%
0.0 0.0
– travel + –time+
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
0%
+100%
+100%
0.0 0.0
GL
GL
GL
fr
fr
fr
---
---
---
Offset
GL
Normal
7
8
Briefl y tap the center SET key of the right touch
pad to activate value setting. The value fi eld will be
displayed in inverse video. Use the selection keys of
the right touch pad to change the value in a range of
0.0 to 9.9 s.
Another brief tap on the center
SET key of the right
touch pad will complete the entry.
A simultaneous tap on the cd or ef keys of the
right touch pad (CLEAR) will reset the changed
parameter displayed in inverse video back to 0.0.
To Next Page
Loading...
Need help?
General
