73
Detail program description - Copy / Erase
7
Copy to phase:
3
5
=>
=>
2
4
6
1
8
… a destination must be selected and it must be
confi rmed too. Another confi rmation request will follow:
Phase to:
to be copied?
NO
YES
1 normal
2 Thermik
A NO response will cancel the process and return
the screen to the originating screen. If the f YES
response is selected and confi rmed with a tap on
the
SET key then the selected source model will be
imported into the selected destination model memory.
Storing changes permanently
Undoing changes
These two sub-menus permit programming changes
to be backed up immediately or to be undone
(restored) to the state when the model was called up
or the state of the last backup.
Copy flight en kopieren
Export to SD
Import fromvon SD-Karte
=>
Store changes ft speichern
Undo changesgig machen
OFFON
Please select
RF on/off?
If the message shown above should appear, the
transmitter's RF module is still active. Switch the RF
module off as described on page 80 then also, if a
receiver system is currently switched on, switch off that
receiver too. This is to be done for reasons of safety.
Data is only backed up by "Store change" or a
switch from one model to another in the »Model
select« menu. Switching the transmitter on or off
will not store the permanently. To store changes
permanently, select the appropriate line then briefl y
tap on the center
SET key of the right touch pad. The
confi rmation request shown below will appear:
Programming changes to be
NO
YES
store permanently?
A NO response will cancel the process and return
the screen to the originating screen. If the f YES
response is selected and confi rmed with a tap on
the SET key then the changes made since the last
backup or model change will be stored permanently.
If, however, the changes made since the last
backup or model change are to be canceled, then
select the line "Undo change". Following a brief tap
on the center
SET key of the right touch pad, the
confi rmation request shown below will appear:
Programming changes to be
NO
YES
reset to original?
A NO response will cancel the process and return
the screen to the originating screen. If the f YES
response is selected and confi rmed with a tap on
the
SET key then the changes made since the last
backup or model change will be stored permanently.
Note:
When the transmitter is switched off, any changes
made will not be lose but they are not permanently
stored either. This means that a subsequent "cancel
changes" would reset memory to the state of the last
"permanent backup" (or model change).
To Next Page
Loading...
Need help?
General
